|300gal Processing Tank
Jacket: ASME certification MAWP 100 PSIG @ 350° F.
CAPACITY: 300 US Gallons + Freeboard.
DIMENSIONS: 42” I.D.
54” Straight Side
10’-0” Approx. Overall Height to the top
24” Outlet height.
DIMENSIONS ARE TO BE VERIFIED ON SUBMITTAL DRAWINGS
MATERIAL: All product contact surfaces are to be 304stainless steel.
All other external surfaces are to be 304 stainless steel.
TOP: Single piece removable flat bridge with two hinged covers with safety grate and proximity switch
ID SHELL: 10 Gauge
ID BOTTOM: 7 Gauge - 120° included angle cone bottom
OD SHELL: 12 Gauge sidewall trim.
OD BOTTOM: 12 Gauge flat bottom trim with a removable vent plug near the low point.
SURFACE: Stainless steel heat transfer surface fabricated on 44 sq. ft. in 1 zone on tank sidewall
and on 6 sq. ft. in one zone on the bottom for use with any heating or cooling media.
Media inlet and outlet connections are to be male NPT. (Less controls).
INSULATION: 2” Chloride & Asbestos free soft fiberglass on sidewall & bottom.
FINISH: All material is to have # 4 finish ID and OD with welds ground and polished to 150 grit finish.
Motor supports, flange feet, leg bracing, manhole hardware, bottom trim and lifting lugs to have scotch brite finish.
OUTLET: (1) 3" Lee Industries air actuated flush mount tank outlet valve with sanitary clamp outlet
in the bottom center
INLETS: (1) 8” connection with funnel to 12” for fill from Sweco filter system in the top
(3) 2” sanitary tri-clamp connections in the top
THERMOWELL: (1) in the bottom head- for RTD - (Less RTD)
LIFTING LUGS: 304 stainless steel
FULLSWEEP: 3 hp single speed inverter duty TEFC motor, operating @ 20 rpm
230/460/60/3 (less switch)
Motor supports - 304 stainless steel
Split seal on the agitator shaft
Food grade lubrication in the gear box
LEGS: (3) with non-adjustable flange feet to be mounted on load cell pads- 304 stainless steel
Includes: horizontal bracing between legs - 304 stainless steel